Sony LMD-1410/1420, LMD-2010/2020 Rear Panel, IN connector, LMD-1420/2020, LMD-1410/2010, OUT connector, (BNC) (LMD-1420/2020), bOPTION AUDIO IN connector (LMD-1420/2020)

Rear Panel

LMD-1420/2020

	LINE A	PARALLEL REMOTE			RGB/COMPONENT				OPTION
					IN	G/Y	OUT		AUDIO IN
										OPTION IN
IN	OUT	IN	LINE B	OUT	IN	B/PB	OUT	IN	EXT	OUT
	VIDEO		VIDEO						SYNC
AC IN
IN	AUDIO OUT	IN	AUDIO	OUT	IN	R/PR	OUT	IN	AUDIO	OUT

87 6 5 4 3 2 1

	LINE A	PARALLEL REMOTE			RGB/COMPONENT				OPTION
					IN	G/Y	OUT		AUDIO IN
										OPTION IN
IN	OUT	IN	LINE B	OUT	IN	B/PB	OUT	IN	EXT	OUT
	VIDEO		VIDEO						SYNC
AC IN
IN	AUDIO OUT	IN	AUDIO	OUT	IN	R/PR	OUT	IN	AUDIO	OUT

LMD-1410/2010

	LINE A	PARALLEL REMOTE			RGB/COMPONENT
					IN	G/Y	OUT
IN	OUT	IN	LINE B	OUT	IN	B/PB	OUT
	VIDEO		VIDEO
AC IN
IN	AUDIO OUT	IN	AUDIO	OUT	IN	R/PR	OUT	IN AUDIO OUT

87 6 5 4

	LINE A	PARALLEL REMOTE			RGB/COMPONENT			OPTION
					IN	G/Y	OUT	AUDIO		OPTION
								IN		IN
IN	OUT	IN	LINE B	OUT	IN	B/PB	OUT	IN	EXT	OUT
	VIDEO		VIDEO						SYNC
AC IN
IN	AUDIO OUT	IN	AUDIO	OUT	IN	R/PR	OUT	IN	AUDIO	OUT

aOPTION IN connector (D-sub 9-pin, female) (LMD-1420/2020)

When optional Sony input adaptor BKM-320D is connected, SDI signals are input.

Press the SDI button to select the signal.

Note

Do not install the equipment other than BKM-320D. It causes to damage the unit or the equipment.

bOPTION AUDIO IN connector (LMD-1420/ 2020)

If the BKM-320D is installed in the OPTION IN connector, input an audio signal into this connector. Press the SDI button to monitor the audio signal.

cEXT SYNC IN/OUT (external sync) connectors(BNC) (LMD-1420/2020)

Press the EXT SYNC button to use the sync signal through this connector.

IN connector

When this unit operates on an external sync signal, connect the reference signal from a sync generator to this connector.

Note

When inputting a video signal with the jitters, etc. the picture may be disturbed. We recommend using the TBC (time base corrector).

OUT connector

Loop-through output of the IN connector. Connect to the external sync input of video equipment to be synchronized with this unit.

When the cable is connected to this connector, the 75-ohm termination of the input is automatically released, and the signal input to the IN connector is output from this connector.

Location and Function of Parts and Controls 15