Press ENTER.
The station is stored.
Press TUNER/BAND repeatedly to select FM or AM.

Tuner

Presetting radio stations

You can preset 20 stations for FM and 10 stations for AM.

1

2 Press and hold m or M until the frequency indication starts to change, then release.

Scanning stops when the system tunes in a station. “TUNED” and “STEREO” (for a stereo program) appear.

TUNED

STEREO

MHz

3 Press TUNER MEMORY.

A preset number appears in the display. The stations are stored from preset number 1.

Preset number

4

5 Repeat steps 1 to 4 to store other stations.

To tune in a station with a weak signal

Press m or M repeatedly to tune in the station manually.

To set another station to an existing preset number

Start over from step 1. After step 3, press . or > repeatedly to select the preset number where you want to store a new station, then proceed to step 4.

Tips

•Pressing TUNER/BAND while the power is off automatically turns the power on.

•You can use the digipad instead of ./>.

•The preset stations are retained for half a day even if you unplug the power cord or if a power failure occurs.

To change the AM tuning interval (Except for European and Middle Eastern models)

The AM tuning interval is factory set to 9 kHz (10 kHz in some areas). To change the AM tuning interval, tune in any AM station first, then turn off the power. While holding down the ENTER button, turn the power back on. When you change the interval, AM preset stations will be erased. To reset the interval, repeat the same procedure.

Listening to the radio

— Preset Tuning

Preset radio stations in the tuner’s memory first (see “Presetting radio stations”).

1 Press TUNER/BAND repeatedly to select FM or AM.

2 Press . or > repeatedly to tune in the preset station you want.

Preset number

Frequency

MHz

To

Do this

Turn off the radio

Press ?/1.

 

 

To listen to non-preset radio stations

In step 2, press m or M repeatedly (Manual Tuning) or press and hold m or M (Automatic Tuning).

Notes

•When the TUNER function is selected, the OSD does not appear on the screen.

•When DVD is selected as the current function and TUNER/BAND is pressed to select the TUNER function, some time may be necessary before the function can be switched.

•When you change the function from DVD to TUNER, “WAIT” may flash on the front panel display. While this flashes, there is no audio output.

40