•No tape is loaded. Load a tape.
•The tab has been removed from the tape. Cover the broken tab with adhesive tape (page 49).
•The tape has reeled to the end.
The system cannot play back the reverse side of the tape in Deck A.•The system only can play back front side of the tape in Deck A. This is not a malfunction.
When you turn . > clockwise or counterclockwise (or press
•The system does not has AMS (Automatic Music Sensor) function. This is not a malfunction.
If the system still does not operate properly after performing the above measures or other troubles does not described above occur, reset the system as follows:
Use buttons on the unit for the operation.
1Unplug the power cord.
2Plug the power cord back in.
3Press ?/1 to turn on the system.
4Press x, ENTER and ?/1 at the same time.
The system is reset to the factory settings. You should set the settings you made, such as the preset stations, clock and timer.
Messages
One of the following messages may appear or flash in the display during operation.
DiscNO STEPYou have cleared all the steps you programmed.
OVERYou have reached the end of the disc while turning and holding m M clockwise (or pressing M on the remote) during playback or pause.
No DiscThere is no disc on the disc tray.
Push STOP!You have pressed PLAY MODE on the remote during playback.
Step Full!You tried to program more than 25 steps.
ReadingThe system is reading information of the disc. Some buttons are not available.
TapeNo TabYou cannot record the tape because the tab has been removed from the tape.
No TapeThere is no tape in the tape deck.