5 Press TUNING +/– (or press
6 Press ENTER.
“Complete!” appears in the display. The station is stored.
7 Repeat steps 1 to 6 to store other stations.Manual tuning presetYou can manually tune in and store the frequency of your favourite stations.
1 Press TUNER/BAND repeatedly to select “FM” or “AM”.
2 Press TUNING MODE on the remote repeatedly until “MANUAL” lights up in the display.
3 Press TUNING +/– (or press
A preset number flashes in the display. The stations are stored from preset number 1.
5 Press TUNING +/– (or press
6 Press ENTER.
“Complete!” appears in the display. The station is stored.
7 Repeat steps 1 to 6 to store other stations.
Other operations
To | Do this |
Tune in a station | Follow the procedure described |
with a weak signal | in “Manual tuning preset” on |
| |
|
|
Stop scanning | Press x. |
during automatic |
|
tuning |
|
|
|
Cancel presetting | Press TUNER MEMORY on |
| the remote. |
|
|
When tuner reception is poor, set the CD power manage function to “CD POWER OFF”. The default setting is “CD POWER ON”.
Use buttons on the unit for the operation.
1Press CD.
2Press ?/1 to turn off the system.
3Press ?/1 while holding x.
The system turns on automatically. “CD POWER OFF” appears in the display.
To set to “CD POWER ON”Repeat the procedure above and “CD POWER ON” appears in the display.
Notes
•When “CD POWER OFF” is selected, disc access time is increased.
•You cannot change the CD power manage function setting in the Power Saving Mode (page 24).
To change the AM tuning intervalUse buttons on the unit for the operation. The factory settings for AM tuning interval is
9kHz (or 10 kHz for some areas). To change the AM tuning interval, select any AM station first, then turn off the system. While holding down ENTER, press ?/1. The system turns on automatically and “AM 10k STEP” or
“AM 9k STEP” appears in the display. When you change the interval, all the AM preset stations are erased. To reset the interval, repeat the same procedure.
Note
You cannot change the AM tuning interval in the Power Saving Mode (page 24).
Tips
•The preset stations are retained for half a day even if you unplug the power cord or if a power failure occurs.
•If you press TUNER/BAND while the system is turned off, the system turns on automatically and “TUNER” is selected as the function.
•You can also press FUNCTION on the remote repeatedly to select “TUNER”.