Press ?/1 to turn on the system.
Press CLOCK/TIMER SET.
Press . or > repeatedly to set the hour.
Press ENTER.

Note

Keep the antennas away from the speaker cords to prevent noise.

3Connect the power cord to a wall outlet.

The demonstration appears in the display. When you press ?/1, the system turns on and the demonstration automatically ends. You can cancel the demonstration by pressing DISPLAY repeatedly (page 29).

Note on placement

Be sure to place this unit on a horizontal place. If the unit is slanted, it may cause malfunction or damage to the system.

Inserting two size AA (R6) batteries into the remote

e

Setting the clock

1

2

3

4

5 Press . or > repeatedly to set the minute.

6 Press ENTER.

The clock starts working.

To adjust the clock

1Press CLOCK/TIMER SET.

2Press . or > repeatedly to select “CLOCK SET”, then press ENTER.

3Do the same procedures as step 3 to 6 above.

Notes

•The clock settings are canceled when you disconnect the power cord or if a power failure occurs.

•You cannot set the clock in Power Saving Mode.

E e

Note

E

If you do not use the remote for a long period of time, remove the batteries to avoid possible damage from battery leakage and corrosion.

Tip

With normal use, the batteries should last for about six months. When the remote no longer operates the system, replace both batteries with new ones.

8GB