Preparations (continued)

Installing the camcorder to the marine packFor DCR-HC40/HC40E/HC30/HC30E/HC20/HC20E/HC18E/HC16E

1Install the camcorder to the marine pack. Connect the remote plug and the microphone plug.

1Connect the microphone plug to the MIC jack (plug in power).

2Connect the remote plug to the LANC jack.

2

front shell

1 to the MIC jack (plug in power)

to the LANCjack

2Insert the camcorder until the mounting shoe clicks into place.

3Connect the monitor cord to the A/V conversion cable attached to the camcorder.

The cords are placed in the

plug holders of the marine

pack at the factory. Pull the

plugs out of the holders when in use.

4Attach the front shell to the rear shell. Hold both shells firmly and fasten the 3 latches securely.

Take care not to pinch the remote, microphone, and monitor cords. If this happens water may leak in.

For details on handling the O-ring, see page 29.

Take care not to pinch the cords.
14-GB