Note on the O-ring (continued)Handling the O-ringSet the O-ring in place

Avoid setting the O-ring in dusty or sandy locations.

1Remove the O-ring.

Do not use pointed or metal objects to remove the O-ring. These objects might scratch or damage the marine pack groove or O-ring.

2Inspect the O-ring.

•Fully check the following, and wipe off with a soft cloth or tissue paper.

Check for any dirt, grains of sand, hair, dust, salt, thread scraps, etc.

Check for any old grease.

v Dirt

v Sand

v Hair

v Dust

vSalt v Thread scraps

•Lightly run your fingertip around the O-ring to check for any unapparent dirt.

•After wiping the O-ring, take care to prevent any cloth or tissue paper fibres from remaining on the O-ring.

•Check the O-ring for cracking, skew, distortion, fine splitting, scratches, sand-biting, etc. Replace cracked or scratched O-rings.

v Cracking

v Skew

v Distortion

v Fine

 

 

 

Splitting

vScratches v Sand-biting

3Inspect the O-ring groove.

Grains of sand or hardened salt sometimes get into the groove. Carefully remove them by blowing with an air spray or by wiping them with a cotton wool bud. Prevent fibre scraps from the cotton wool bud from entering inside.

4Also, inspect the contacting surface on the other side of the O-ring in the same way.

30-GB