Sony MZ-DH10P 888 SET OK ##, 888 RMC OK ##

MZ-DH10P

Flow of Self-diagnosis Result Display mode operation:

					The first error
	*** 1 ####
	[VOL +] key			[VOL --] key
					The last error
	*** N ####
	[VOL +] key			[VOL --] key
					One error before
	*** N1####
					the last
	[VOL +] key			[VOL --] key
					Two error before
	*** N2####
					the last
	[VOL +] key			[VOL --] key
					Total recording time
	*** R_####
	[VOL +] key			[VOL --] key
7-2. Error Code of The Self-Diagnosis Result Display
	Mode
Error display code				Description
000		No error
001		Attempt to access an abnormal address
002		High temperature detected
003		Focus error (no change)
004		Abnormal rotation of disc
005		Fault of disc discriminate
006		Error of access loop (no change)
007		Error of access loop (with change)
008		Could not read address
009		Focus error (with change)
012		Could not read data with SYNC
013		TOC address data error
032		Focus error, ABCD offset error
033		Tracking error, offset error
034		X1 tracking error, Tracking error, offset error
Error display code			Addition information when error occurs
000		0000
001		Illegal cluster specified when error occurs
	002 to 034	Total recording time when erroe occurs

7-3. Clear The Total Recording Time

After replacing the optical pick-up, clear the total recording time.

1.Enter the test mode (Display Check mode).

2.Press the > key to activate the Self-Diagnosis Result Display mode.

3.Press the [VOL--]key once to display the total recording time indication.

4.	Press the	+	,	u ENT	key on the set or	–	key on the
	remote commander and display “ClrOK?”.
5.	Press the		,		key on the set or		key on the
		+		u ENT		–
	remote commander again to display “RecT 0” and clear the
	total recording time.

8.KEY CHECK MODE

This mode is used for key check.

Operation of The Key Check Mode

1.Enter the test mode (Display Check mode).

2.Press the [DISPLAY]key to activate the Key Check mode where the LCD displays as shown below.

Display of the remote commander

110 $$$$$$ ##

“$$$$$$” : Pressed key name.

When remote commander key is pressed, display becomes as “r$$$$$”.

When the jog dial is turned, it displays “JOG+ X” or “JOG- X” (“X” is number of 1 to 3). If the jog dial is turned four click, it displays “JOG+OK” or “JOG-OK”.

“##” : Key voltage of remote commander. (Hexadecimal number)

3.When all keys check is OK on the main unit, it displays as follows.

Display of the remote commander

888 SET OK ##

When all keys check is OK on the remote commander, it displays as follows.

Display of the remote commander

888 RMC OK ##

4.When all keys check are OK both the main unit and the remote commander, it display backs to the Display Check mode automatically.

5.To release the Key Check mode, open the lid and return to the Display check mode.

16