Power Supply Adjustment Auto Item Feed
Note: This mode is available to perform the temperature correction and power supply adjustment without entering the manual mode.
• Setting method of power supply adjustment auto item feed mode.
1.Set the test mode (see page 13)
2.Press the . key or press the [VOL
Set LCD display
000Assy **
3.Press the [END SEARCH] key to set the temperature correc- tion mode.
Set LCD display
0 15 | SetTmp |
Set LCD display
7 41 | VC1 L |
5.Connect a digital voltmeter to the measuring points on the MAIN board, and adjust the voltage with the [VOL +] or [VOL
Press the X key to write the adjusted value, and the item num- ber increases automatically.
6.When not writing the adjusted value, press the > key to move to the next item. The . key is available to back to the last item.
7.The following message is displayed after all power supply adjustments finish.
Set LCD display
0 00 | ADJ OK |
4.To change the initial value (not displayed) adjust with the [VOL +] or [VOL
Press the X key to write the adjusted value, and the item num- ber increases automatically.
When not writing the adjusted value, press the > key to move to the next item.
• Configuration of power supply adjustment auto item feed
8.Press the xCANCEL/CHG play check mode).
key to return the test mode (dis-
000Assy **
END SEARCH
key
749 REG3 H
015 SetTmp
. key
> key
. key
> key
751 VREC L
741 VC1 L
. key
> key
. key
> key
752 VREC M
742 VC1 H
. key
> key
. key
> key
753 VREC H
743 VC2 Lo
. key
> key
. key
> key
755 ChgV L
744 VC2 Hi
. key
> key
. key
> key
756 ChgV H
745 REG1
. key
> key
. key
> key
757 CIL **
747 REG3L1
. key
> key
. key | > key | ||
|
| ||
|
|
|
|
748 REG3L2
. key | > | key |
|
|
758 CIH ** > key
000 ADJ OK
25
