BEditing recorded tracks

You can edit your recordings by adding/ erasing track marks or labeling tracks and discs.

Premastered MDs cannot be edited.Notes on editing

•Do not move or jog the recorder while “TOC Edit”* is flashing in the display.

•You cannot edit tracks on an MD that is record -protected. Before editing tracks, close the tab on the side of the MD.

•If you perform an editing operation while playing, be sure not to turn the power off until “TOC Edit” disappears in the display.

•The lid does not open until “TOC Edit” disappears in the display after editing.

*TOC = Table of Contents

Erasing a trackSee the illustration in the Japanese text (page 43).

You can quickly erase a recorded track. Note that once a recording has been erased, you cannot retrieve it. Make sure of the track you are erasing.

1While playing the track you want to erase, press the jog lever (L), flip the lever repeatedly until “EDIT” flashes in the display, and then press the lever again.

“ : Name” flashes in the display, and the recorder plays the selected track repeatedly.

2Flip the jog lever (L) until “ : Erase” flashes in the display, and then press the lever.

“Erase OK?” and “PushENTER” appear alternately in the display. To cancel erasing, press x.

3Press the jog lever (L) again.

The track is erased and the next track starts to play. All the tracks after the one erased are automatically renumbered.

To erase a part of a track
Erasing a whole discSee the illustration in the Japanese text (page 44).

You can quickly erase all the tracks and data of the MD at the same time. Note that once a recording has been erased, you cannot retrieve it. Be sure to check the contents of the disc you want to erase.

1While the recorder is stopped, press the jog lever (L), flip the lever until “EDIT” flashes in the display, and then press the lever again.

“ : Name” flashes in the display.

2 Flip the jog lever (L) until “ : Erase” flashes in the display, and then press the lever.

“AllErase?” and “PushENTER” appear alternately in the display.To cancel erasing, press x.

3Press the jog lever (L) again.

“TOC Edit” flashes in the display, and all the tracks will be erased.When erasing is complete, “BLANKDISC” appears in the display.Adding a track mark

See the illustration in the Japanese text (page 44).

You can insert a track mark into a track.

1While playing or pausing an MD, press T MARK on the recorder at the point you want to mark.

“MARK ON” appears in the display, and the track mark is added.To add track marks while recording (except while synchro- recording)

Press T MARK at the point you want to add a track mark. You can use Auto Time Stamp to add track marks automatically at specified intervals.

Add track marks at the beginning and the end of the part you want to erase, then

86 erase the part.