Troubleshooting (continued)

Symptom

Cause/Solution

 

 

The MD does not play

• Stop playback when another play mode is selected. Then press and

normally.

hold the jog lever for two seconds or more.

• When the repeat play is selected, press and hold the P-MODE/ button for two seconds or more until disappears.

The MD does not play from the first track.

•Playback with same MD starts from the point you last stopped playing.

To start playback from the beginning of the same MD, press and hold the jog lever on the remote for two seconds or more (or press and hold the 5-way control key on the player toward  for two seconds or more). Or you can press  (stop) button and reinsert the MD. Playback will start from the beginning because the player will consider the MD to be a different one.

The playback sound skips.

• When you use the player in a location that has a lot of vibration, place

 

the player where the vibration is the least.

 

• A very short track, such as a brief narration or introduction, may

 

cause sound to skip.

 

• Do not continuously give strong shocks to the player.

 

• Do not use a dirty or scratched MD.

 

 

Noise is heard.

• Move the player away from a television or other source of strong

 

magnetism which is causing interference.

 

 

Noise is briefly heard.

• Because of the nature of the compression method used in the LP4

 

mode, noise may be output on very rare occasions during playback of

 

sound recorded in this mode.

 

• Noise may be output when the cord of the headphones touches the

 

clothing, etc. This is not a malfunction.

 

 

During playback, the

• When “Power Mode” is set to “Power Save,” the lamp and display do

operation lamp of the player

not light up except during operation. Select “Quick” or “Normal”

or the remote display does

(page 31).

not light up.

 

The group settings do not function.

•Insert an MD with group settings (page 25).

40