3 Select “SETUP,” and press ENTER.
4 Select “Others,” and press ENTER.
5 Select “Command Mode,” and press
ENTER.
6 Select a Command Mode (DVD1, DVD2, or DVD3), and press ENTER.
7 Set the Command Mode for the remote so it matches the Command Mode for the recorder you set above.
Follow the steps below to set the
Command Mode on the remote.
1Hold down ENTER.
2While holding down ENTER, enter the Command Mode code number using the number buttons.
Command Mode Code number
DVD1 | number button 1 |
|
|
DVD2 | number button 2 |
|
|
DVD3 | number button 3 |
3Hold down both the number and ENTER buttons at the same time for more than three seconds.
To check the Command Mode for the recorder
Press x on the recorder when the recorder is turned off. The Command Mode for the recorder appears in the front panel display.
If the Command Mode for the recorder has not been changed, set the Command Mode for the remote to the default setting of DVD3. If the Command Mode for the remote is changed to DVD1 or DVD2, you will be unable to operate this recorder.
Changing programme positions of the recorder using the remoteYou can change programme positions of the recorder using the number buttons.
Number buttons
ENTER
Example: for channel 50
Press “5,” “0,” then press ENTER.
Settings and Hookups
19