Connecting the FM wire antenna (aerial)

Connect the FM wire antenna (aerial) to the 75 Ω COAXIAL jack.

Bundling the cables

1 Connect the components to the stand.

For details, refer to pages 11 to 15.

2 Bundle the cables with the cord manager to prevent them from tangling.

Stuff the cables into the cord manager as shown in the illustration below.

HDMI

BD IN

DVD IN

SAT IN

TV OUT

 

FM

 

75

 

ANTENNA

 

COAXIAL

FM wire antenna (aerial) (supplied)

75 Ω COAXIAL jack

Notes

Be sure to fully extend the FM wire antenna (aerial).

After connecting the FM wire antenna (aerial), keep it as horizontal as possible.

If you have poor FM reception, use a 75-ohm coaxial cable (not supplied) to connect the control unit to an outdoor FM antenna (aerial) as shown below.

Outdoor FM antenna (aerial)

FM

75

ANTENNA

COAXIAL

Rear of the stand

Installing this stand

Install the stand after connecting all the components to the stand.

Install the stand after allowing for a space of more than 5 cm from the wall. This is to allow for heat dissipation and to prevent the TV from falling.

More than 5 cm

Note

Be careful not to pinch your fingers when setting up the stand.

10GB