Inputs (Digital) |
|
TV, DVD | Optical |
SAT | Coaxial, optical |
FM tuner section |
|
System | PLL |
| synthesizer |
Tuning range | 87.5 – 108.0 MHz |
| (50 kHz step) |
Antenna (aerial) | FM wire antenna (aerial) |
Antenna (aerial) terminals | 75 ohms, unbalanced |
Intermediate frequency | 10.7 MHz |
HDMI section |
|
Connector | HDMI |
| connector |
Video inputs/outputs | BD, DVD, SAT: |
| 640 × 480p@60 Hz |
| 720 × 480p@59.94/60 Hz |
| 1440 × 480p@59.94/60 Hz |
| (pixel sent 2 times) |
| 1280 × 720p@59.94/60 Hz |
| 1920 × 1080i@59.94/60 |
| Hz |
| 1920 × 1080p@59.94/60 |
| Hz |
| 720 × 576p@50 Hz |
| 1440 × 576p@50 Hz (pixel |
| sent 2 times) |
| 1280 × 720p@50 Hz |
| 1920 × 1080i@50 Hz |
| 1920 × 1080p@50 Hz |
| 1920 × 1080p@24 Hz |
Audio inputs | BD, DVD, SAT: Linear |
| PCM 7.1ch/Dolby Digital/ |
| DTS |
Speakers |
|
Front speaker unit |
|
Speaker system | |
| Magnetically shielded |
Speaker unit | Woofer: 50 mm, cone type |
| Tweeter: 25 mm, balanced |
| dome type |
Center speaker unit |
|
Speaker system | |
| Magnetically shielded |
Speaker unit | Woofer: 50 mm, cone type |
| × 2 |
| Tweeter: 25 mm, balanced |
| dome type |
Surround speaker unit
Speaker system | Full range, |
| Acoustic suspension, |
| Magnetically shielded |
Speaker unit | 50 mm, cone type |
Subwoofer unit |
|
Speaker system | Bass reflex |
Speaker unit | 100 mm, cone type × 2 |
General |
|
Power requirements | European model: |
| 220 – 240 V, 50/60 Hz |
Power consumption On: 110 W
Active Standby (Control for HDMI is on):
1.5 W or more
Standby (Control for HDMI is off): less than 0.3
W |
|
Dimensions (approx.) |
|
1,115 × 500 × 400 mm | |
| (w/h/d) |
1,550 × 400 × 400 mm | |
| (w/h/d) |
Mass (approx.) |
|
54 kg | |
59 kg |
Supplied accessories
Optical cable (1 m) (1)
Remote commander
Top glass panel (1) Corner protectors (4)
Support belt and two screws (small/large) (1) Shelf board (1)
Shelf support pins (4)
Operating Instructions (1)
Design and specifications are subject to change without notice.
• Standby power consumption 0.3 W.
• Halogenated flame retardants are not used in the printed wiring boards.
•Over 85 % power efficiency of amplifier block is achieved with the full digital amplifier,
•Halogenated flame retardants are not used in cabinets.
Information Additional