Control for HDMI
If you experience any of the following difficulties while using the “BRAVIA” Sync, use this troubleshooting guide to help you remedy the problem.
The Control for HDMI function does not work.
•Check the HDMI connection (page 11).
•Make sure “CTRL: HDMI” is set to “ON” in AMP menu.
•Make sure the connected component is compatible with the Control for HDMI function.
•Check the Control for HDMI settings on the connected component. See the operating instructions supplied of the connected component.
•If you change the HDMI connection, connect/disconnect the AC power cord (mains lead), or there is a power failure, repeat the procedures of ““BRAVIA” Sync Features” (page 27).
•The stand may not work correctly if you select a component that is not compatible with the Control for HDMI function on the TV side.
•Make sure “DVD CTRL”, “SAT CTRL” or “DMPORT. CTRL” is set to “ON” in AMP menu.
No sound is output from the stand and TV speaker.
•Check the volume of the stand and the TV.
•Select the input of the stand correctly.
The sound is output from both the stand and the TV.
•If the Control for HDMI function is set to off, or the selected component is not compatible with the Control for HDMI function, turn off the sound of the stand or the TV.
The System Power Off function does not work.
•Change the setting of the TV to turn connected components off automatically when you turn off the TV. For details, refer to the operating instructions of the TV.
An image does not appear on the TV.
•Check whether HDMI IN and HDMI OUT are connected in reverse.
A message stating that the output method has changed from the stand speaker to the TV speaker, appears on the TV screen.
•The Control for HDMI function for the selected component is set to off. For details, refer to “Connecting components without HDMI jacks” (page 13).
OTHER
The remote does not function.
•Point the remote at the remote sensor 
on the stand.
•Remove any obstacles in the path between the remote and the stand.
•Replace both batteries in the remote with new ones, if they are weak.
•Make sure you select the correct input on the remote.
The volume turns down when the output method changes from the TV speaker to the stand speaker.
•The Volume Limit function is working. For details, refer to “Using the Volume Limit function” (page 31).
If the stand still does not operate properly after performing the above measures, reset the stand as follows:
Use buttons on the stand for the operation.
1 Press ?/1 to turn on the power.
2 Press ?/1 while pressing INPUT
SELECTOR and VOLUME –.
“COLD RESET” appears and the stand is reset. AMP menu, sound field etc., return to the default settings.