BBV Rx 100 Interface Receiver
Addendum to manual for the following domes:
Panasonic
Rx100 software RX1_P1V5B
Application Notes
Variable speed Pan/Tilt. |
|
Zoom/Focus, Autofocus, Iris Open/Close | (AutoFocus with 600 & 650 series) |
16 full scene presets | (600 & 650 series dome) |
2 preset patrols | (600 & 650 series dome) |
4 alarm inputs driving to preset 1 - 4. | (600 & 650 series dome ) |
Autopan |
|
|
|
|
Advanced Features | Tx400 | Tx1000 | Tx1500 DM Sprite/DSL/DS2/BX2 | |
Entry/Exit Dome Menu | ‘#’ 1 | '#' WASH | 1 ‘#’ | *889 002 or *889 10 10 2 |
SET (select menu item) | ‘#’ 2 | '#' WIPE | 2 ‘#’ | *889 003 or *889 10 10 3 |
ESC (back to previous menu) | ‘#’ 3 | '#' AUTOPAN | 3 ‘#’ | *889 004 or *889 10 10 4 |
SPECIAL2 (for special menus) | ‘#’ 4 | '#' LIGHTS | 4 ‘#’ | *889 005 or *889 10 10 5 |
Autopan is started by selecting Autopan on the Transmitter. The Autopan stops can be programmed from within the dome menu. Please refer to dome user manual for exact details.
RS485 control of dome. Connect dome
Dome Cable | Description | Rx100 |
Yellow | Data- | J3/C1 |
Green | Data+ | J3/C2 |
Notes:
The alarm output relay opens for approx 5 seconds upon power up. This can be used to signal power loss, etc.
Accessing the dome menus.
Press either '#'WASH , '#'1 or *889 002 key strokes to Enter Menu. Use Pan/Tilt to highlight item. Press either '#'WIPE, '#'2 or *889 003 key strokes to select menu item. To exit from menu, press either '#'WASH, '#'1 or *889 002.
Check with the multiplexer manual for exact procedure for entering * commands.
IMPORTANT: Dome settings: Select dome address 01. Communications must be 19200, N, 8, 1. If dome cannot be controlled, see dome manual section to reset dome to factory default.
The Panasonic
The TEST link will pan the dome left whilst shorted. The video out BNC must be disconnected before the TEST link is fitted. The GREEN DATA flashes when data is sent from the Rx100.
Rx100 installation manual V1.17 29 Aug 08.doc | Page 23 |
