BBV Rx 100 Interface Receiver
Addendum to manual for the following domes:
VCL TP protocol Microsphere/Orbiter range.
Rx100 software RX1_V1V10
Application Notes
The RX 100 provide the following functionality when controlling the above mentioned domes
Variable speed Pan/Tilt.
Zoom/Focus, Autofocus following a Zoom In/Out.
16 Full scene presets.
2 preset patrols.
Slow preset tour. Started by pressing AUTOPAN
5 minute datum/park driving to preset 8 disabled by removing link
Additional commands:
AUTOPAN: Pressing the AUTOPAN key will run the domes preset tour at slow speed between the patrol 1 preset positions.
Advanced Features | Tx400 | Tx1000 | Tx1500 | DM DS/DS2/BX2 Mux |
|
180 degree pan flip | ‘#’ 1 | '#' WASH | 1 ’#’ | *889 002 or *889 10 10 2 | |
Privacy SET (Toggle Mono/Colour) | ‘#’ 2 | '#' WIPE | 2 ’#’ | *889 003 or *889 10 10 3 | |
Privacy CLEAR (Auto Mono/Colour) | ‘#’ 3 | '#' AUTOPAN | 3 ’#’ | *889 004 or *889 10 10 4 | |
Reset dome parameters | ‘#’ 4 | '#' LIGHTS | 4 ’#’ | *889 005 or *889 10 10 5 | |
The dome and Rx100 are linked using RS485 for control and video for the camera signal.
Rx100 | Description | Dome connection |
D- | ||
TX+/A | D+ |
Notes:
The dome address must be set at 1 for all the cameras that are controlled using a Rx100. With an Orbiter Gold, set the address to 1 with all switches of DILSW2 ON. Select VCL protocol with all switches of DILSW1 OFF. Check with the dome manual if you have any doubts.
The alarm output relay opens for approx 5 seconds upon power up and following any active alarm input.
If the slow preset tour is running, start patrol 1 & 2 is inhibited. The dome will be driven to a preset following an alarm activation. 60 seconds after alarm, the tour will restart. A manual goto preset and lens control will stop the tour leaving the AUTOPAN led on until the next manual pan command.
A datum/park mode is offered that drives the dome to preset 8 following 5 minutes of inactivity. This can be disabled by removing the link fitted across J6/pin 4 & 5 and refitting to J6/pin 3 & 4.
Privacy zone programming.
Link
– The keystrokes shown assume use of a TX1500. Use the keystroke shown above if using another controller.
Programming a zone
The Rx100 can be used to program 16 privacy zones, 100 – 115. The same procedure that is used to program a preset position is used to program or clear a privacy zone. To instruct the Rx100 to program privacy press 2# followed by program preset 1 – 16. The screen will then go blank showing that the privacy zone has been set.
Clearing a zone
To clear/delete a privacy zone press 3# followed by program preset 1 – 16. The relevant privacy zone will then be disabled.
Mono/Colour switching
If manual mono/colour switching is required then link
Rx100 installation manual V1.17 29 Aug 08.doc | Page 33 |
