Setting up the G-CODE system for satellite broadcasts (if applicable)

When your satellite tuner is connected via the AERIAL IN connector, first you have to set the programme position for each satellite channel using the TUNER PRESET menu. Then set the guide channel number for each satellite channel using the SET UP CH AND G-CODE menu.

If your satellite tuner is connected via the LINE-1 IN jacks, you do not have to set programme positions nor guide channel numbers for satellite channels. Skip the following operations.

1Turn on the satellite tuner.

2Press MENU, then select TUNER PRESET and press OK.

3Press M/m/</, to select AUS or NZ, depending on the country you live in.

4Press PROG +/– to select a programme position you want to use for watching a satellite channel.

Started Getting

5Select CHANNEL SET, then press / to tune the VCR to the satellite tuner.

The channel number displayed beside CHANNEL SET is used for receiving all satellite broadcasts from the satellite tuner.

TUNER PRESET

 

PROG 6

COUNTRY

• AUS

NZ

NORMAL / CATV • NORM

CATV

AUTO PRESET

 

CHANNEL SET

30

 

ADD / ERASE

• ADD

ERASE

AFT

 

• ON

OFF

FINE TUNING

 

 

SELECT

: [

]

 

SET

: [

]

 

6Press PROG +/– to select another programme position for another satellite channel, and press the programme number buttons to enter the same channel number as the one displayed in step 5.

Repeat this step for all satellite channels.

7Set the guide channel number for each programme position assigned to the satellite channel, following the procedures in “Setting up the G-CODE system manually” on page 23.

Notes

•The menu disappears automatically if you do not proceed for more than a few minutes.

•If you inadvertently entered a guide channel number, press >/. repeatedly to reset the “GUIDE CH” column to “---”. “---” appears between 1 and 255.

•The VCR does not allow entering the guide channel number, if the same number has been set.

•If you use a satellite tuner connected via the LINE-1 IN jacks, you do not have to set up the G-CODE guide channels. Just record a satellite programme using the G-CODE number, and the VCR automatically records the programme from the LINE-1 IN jacks.

•When you record a satellite broadcast using the G-CODE number, you need to select the desired channel on the satellite tuner manually.

Getting Started 25