Additional Information
Troubleshooting
If you experience any of the following difficulties while using the tuner, use this troubleshooting guide to help you remedy the problem. Should any problem persist, consult your nearest Sony dealer.
There’s no sound.cConnect the aerials.cSet the source setting on the amplifier to TUNER.cThere is no sound while receiving the DAB data broadcast. In this case, “DATA” appears in the display.
cThe specified station has temporarily stopped broadcast.You cannot tune in a frequency.cAdjust the position of the aerial.cConnect an external aerial for DAB/FM broadcasts.cSet IF BAND to “NARROW”.cPreset the stations again if you've moved.There is severe hum and/or background noise.cAdjust the position or direction of the aerial.cTune to a correct frequency.cConnect an external aerial for DAB/FM broadcasts.
cMove the tuner away from the source of the noise.RDS isn‘t working.cMake sure that you tune in an FM station.cSelect a stronger FM station.“EEPROM R/W ERROR” appears in the display.cThere are some trouble with the internal microprocessor in the tuner. Preset stations again.
The station was interrupted by another station / The tuner automatically starts searching for stations.
cThe EON function is working. Turn off EON when you don't want the current programme interrupted.
The appropriate display or information does not appear.cContact the radio station and find out whether or not they actually provide the service in question. The service may be temporarily out of order.
You cannot name the preset station.cYou cannot name DAB/FM RDS stations.You cannot receive the DAB data broadcastcConnect an external data receiver for DAB data broadcasts to the DAB RDI OUT connector.
cThe specified station has temporarily stopped the broadcast. Wait for the broadcast to resume.
cThe microprocessor in the tuner has malfunctioned. Turn off the tuner, then turn it on again.
There’s no sound from the DAB DIGITAL OUT connector, or you cannot record the programme.
cYou are receiving a DAB data broadcast. Receive an audio programme.cMake sure that the digital connecting cable is properly connected.cThe copy protection signal is included in the programme. Input the sound to the recorder, which is output from the ANALOG OUTPUT connector of the tuner.
cThe connected recorder does not support the 48kHz sampling frequency mode. Use a recorder that supports this mode.
cThe sound of the FM and AM programme is not output from the DIGITAL OUT connector of the tuner. Connect the recorder to the ANALOG OUT connector of the tuner.