Advanced Tuner Operations

zIf the STEREO indicator remains off

Press MONO/SC when an FM stereo broadcast is received.

zIf an FM stereo programme is distorted

Press MONO/SC to change to monaural (MONO). You will not have the stereo effect but the distortion will be reduced. To return to stereo mode, press this button again.

Naming the Preset Stations

You can assign a name of up to 16 characters long to each preset station except DAB and FM RDS stations. When the station is tuned in, the station name will appear.

MEMORYTUNING/SELECT

zWhen you preset a FM station, current settings of ANTENNA ATTENUAT, IF BAND WIDTH and FM mode are stored simultaneously

If you want to store other settings, change settings according to the procedures in “Tips for Better FM Reception” on page 18 after performing step 3, then perform step 4.

When you want to change the settings for the preset station, tune the station and change the setting. Then, press MEMORY and ENTER.

Note

You cannot preset the secondary component (SC) of a DAB broadcast. Store the service which contains the desired component, then switch the component by pressing MONO/ SC when you want to receive the component.

CHARACTERENTER1Tune in the preset station you want to name.2Press CHARACTER.The cursor flashes in the display.3Turn TUNING/SELECT to select a character.

4When the character you want appears, press CHARACTER to move the cursor into position for the next character.

If you make a mistake

Press CHARACTER repeatedly until the character you want to change flashes (every time you press CHARACTER, the next character flashes). Then turn TUNING/SELECT to select a new character.

5Repeat steps 2 and 3 until the station name you want appears in the display.6Press MEMORY.“MEMORY” appears along with the preset number.7Press ENTER.“PRESET Memory OK” appears.zWhen you name the station by Automatic tuning or Manual tuning

After the step 6 above, “MEMORY” appears along with the lowest vacant number to indicate that the tuner stores the station.

Notes

•The display returns to normal display mode if you stop assigning names for more than 60 seconds. If this happens, start again from the beginning.

•If you name a station which has a preset name already, the previous preset name is deleted.

•“No Name” appears when you display a preset station without the preset name.

•You cannot use “ ” (blank space) only for the preset name.

12GB