REAR R

Getting Started

Selecting the impedance

Set the IMPEDANCE SELECTOR for the front speakers as indicated in the table below. Check the instruction manual of your speakers if you’re not sure of the impedance. (This information is usually printed on a label on the back of the speaker.)

If the nominal impedance of

Set IMPEDANCE SELECTOR

your speaker is

to

 

 

Between 4 and 8 ohms

 

 

8 ohms or higher

 

 

Note

Be sure to connect the front speakers with nominal impedance of 8 ohms or higher if you want to select both sets of front speakers (see page 12).

Rear and center speakers

Rear speaker

Receiver

Rear speaker

(R)

Center speaker

(L)

 

SPEAKERS

 

 

 

REAR

CENTER

 

 

 

R

L

 

 

 

R

L

 

 

To avoid short-circuiting the speakers

Short-circuiting of the speakers may damage the receiver. To prevent this, make sure to take the following precautions when connecting the speakers. Make sure the stripped ends of each speaker cord does not touch another speaker terminal or the stripped end of another speaker cord.

Examples of poor conditions of the speaker cord:

R

REAR

 

R

L

 

 

 

+

After connecting all the components, speakers, and AC power cord, output a test tone to check that all the speakers are connected correctly. For details on outputting a test tone, refer to “Adjusting the speaker volume” on page 10.

If you have connected rear speakers, be sure to press the 5.1 CH/DVD button and turn off sound field on the receiver before outputting a test tone so that the tone is output individually from the left and right rear speakers.

If no sound is heard from a speaker while outputting a test tone or a test tone is output from a speaker other than the one whose name is currently displayed on the receiver, the speakers may be short-circuited. If this happens, check the speaker connection again.

Active woofer

 

 

 

 

 

* STR-DE535 only

 

STR-DE435 only

Receiver

Active woofer

 

 

 

 

WOOFER

Receiver

Active woofer

 

INPUT

AUDIO

 

OUT

 

 

 

 

 

 

 

 

 

WOOFER

INPUT

 

 

 

AUDIO

 

 

 

 

 

 

OUT

 

 

 

 

 

 

 

 

 

*You can connect the active woofer to either of the two jacks. The remaining jack can be used to connect a second active woofer.

Note

Do not connect any other component.

If you have an additional front speaker system

Connect them to the SPEAKERS FRONT B terminals.

If your TV monitor uses separate speakers

You can connect one of them to the SPEAKERS CENTER terminals for use with Dolby Pro Logic Surround sound (see page 10).

Where do I go next?

To complete your system, go to “AC Hookups” on page 9.

Stripped speaker cord is touching another speaker terminal

R

L

+

Stripped cords are touching each other due to excessive removal of insulation.

8US