123US
D:\NORM'S JOB\SONY HA\SO120031\STR-DA1800ES_PMRF
02\4428194122_USFR\US07ADD_STR-DA1800ES-CEL.fm masterpage: Right
STR-DA1800ES
4-428-194-12(2)
Additional Information
• Check that the cord(s) used for the
connection is (are) fully inserted into the
jacks on both the receiver and the
equipment.
• Check the INPUT MODE (page 91).
• Check that the equipment is connected
correctly to the HDMI jack for that
equipment.
• The sound from Super Audio CD player
can’t output from OPT or COAX
connection. Change to analog 2CH or
HDMI connection.
• Depending on the playback equipment,
you may need to set up the HDMI setting
of the equipment. Refer to the operating
instructions supplied with each
equipment.
• Sound may not be output from the receiver
while the GUI appears on the TV screen.
Press GUI MODE to select “GUI OFF”.
• Audio signals (format, sampling
frequency, bit length, etc.) transmitted
from an HDMI jack may be suppressed by
the connected equipment. Check the setup
of the connected equipment if the image is
poor or the sound does not come out of the
equipment connected via the HDMI cable.
• When the connected equipment is not
compatible with copyright protection
technology (HDCP), the image and/or the
sound from the HDMI OUT jack may be
distorted or may not be output. If this is the
case, check the specification of the
connected equipment.
• Set the image resolution of the playback
equipment to more than 720p/1080i to
enjoy High Bitrate Audio (DTS-HD
Master Audio, Dolby TrueHD).
• The image resolution of the playback
equipment may need to be at certain
settings before you can enjoy Multi
Channel Linear PCM. Refer to the
operating instructions of the playback
equipment.
• Make sure the TV is compatible with the
System Audio Control function.
• If the TV does not have System Audio
Control function, set the “Audio Out”
settings in HDMI Settings menu to
– “TV+AMP” if you want to listen to the
sound from the TV speaker and
receiver.
– “AMP” if you want to listen to the
sound from the receiver.
• When you connect the receiver to a video
equipment (projector, etc.), sound may not
be output from the receiver. In this case,
set the “Audio Out” to “AMP” in the
HDMI Settings menu (page 103).
• If you cannot listen to the sound of the
equipment connected to the receiver while
TV input is selected on the receiver
– Be sure to change the input of the
receiver to HDMI when you want to
watch a program on the equipment
connected via HDMI connection to the
receiver.
– Change the TV channel when you want
to watch a TV broadcast.
– Be sure to select the correct equipment
or input you want when you watch a
program from the equipment connected
to the TV. Refer to the operating
instructions of the TV on this operation.
• Check that the “A. DIRECT” is not being
used.
• When using the Control for HDMI
function, you cannot control the connected
equipment using TV’s remote control.
– Depending on the connected equipment
and TV, you may need to set up the
equipment and TV. Refer to the
operating instructions supplied with
each equipment and TV.
– Change the input of the receiver to the
HDMI input connected to the
equipment.
• Check that the selected digital audio input
jack is not reassigned to other inputs
(page 92).
continued