41US
D:\NORM'S JOB\SONY HA\SO120031\STR-DA1800ES_PMRF
02\4428194122_USFR\US04GET_STR-DA1800ES-CEL.fm masterpage: Right
STR-DA1800ES
4-428-194-12(2)

Preparing the Receiver

Connecting the AC power

cord (mains lead)

Connect the AC power cord (mains lead) to a
wall outlet.
A several space is left between the plug and the
rear panel even when the power cord (mains
lead) is inserted firmly. The cord is supposed
be connected this way. This is not malfunction.

Turning on the receiver

Press ?/1 to turn on the receiver.
You can also turn on the receiver using ?/1 on
the remote control.
When you turn off the receiver, press ?/1
again. “STANDBY” flashes on the display
window. Do not disconnect the AC power cord
(mains lead) while “STANDBY” is flashing.
This may cause a malfunction.
Note
When the receiver is in standby mode, the
ON/STANDBY indicator on the front panel lights
up in amber.

To save the power in standby

mode

Set “Ctrl for HDMI” (page 103), “Pass
Through” (page 103), “Network Standby”
(page 106) and “BT Standby” (page 107) to
“OFF”, and turn off the power for zone 2.
If “Ctrl for HDMI” (page 103), “Pass
Through” (page 103), “Network Standby”
(page 106), or “BT Standby” (page 107) is set
to “ON”, or the power for zone 2 is turned on,
the lamp above ?/1 lights up in amber.
Note
The top of the receiver may become hot while the
receiver is in standby mode. This condition occurs
because current is flowing in the internal circuits of
the receiver. This is not a malfunction.

Preparing the Receiver

AC IN terminal
To the wall outlet
AC power cord
(mains lead)
(supplied)
?/1