4:Connecting the AC power cord
Connect the supplied AC power cord to the AC IN terminal on the receiver, then connect the AC power cord to a wall outlet.
AC power cord
| AC OUTLET | * |
|
S2 VIDEO | S2 VIDEO | S2 VIDEO |
IN | OUT | IN |
VIDEO | VIDEO | VIDEO |
AUDIO | AUDIO | AUDIO |
AC OUTLET
EO 2 | VIDEO 1 |
AL
SUB
WOOFER
BL
RONT SPEAKERS | AUDIO OUT |
AC IN
terminal
*The configuration, shape, and number of AC outlets vary according to the area code.
Notes
•The AC OUTLET(s) on the rear of the receiver is a switched outlet, which supplies power to the connected component only while the receiver is turned on.
•Make sure that the total power consumption of the component(s) connected to the receiver’s AC OUTLET(s) does not exceed the wattage stated on the rear panel. Do not connect
fans, or TVs to this outlet. This may cause a malfunction.
Before using the receiverPerforming initial setup operationsBefore using the receiver for the first time, initialize the receiver by performing the following procedure.
This procedure can also be used to return settings you have made to their factory defaults.
1Press ?/1 on the receiver to turn off the receiver.
2Hold down ?/1 on the receiver for 5 seconds.
3While “ENTER to Clear All” appears in the display, press MEMORY/ENTER on the receiver.
After “MEMORY CLEARING...” appears in the display for a while, “MEMORY CLEARED!” appears.
The following are reset to their factory settings.
•All settings in the SPEAKER SET UP,
LEVEL, SURR SET UP, EQUALIZER, CUSTOMIZE, TUNER and CIS (models of area code U, CA only) menus.
•The sound field memorized for each input and preset station.
•All preset stations.
•All index names for inputs and preset stations.
Note
If “2nd zone on” or “3rd zone on” appears in the display, the initial setup operation cannot be performed. Turn off the indication by following the first tip of “Listening to the sound in another zone” (page 52).
Before using the remote for the first timeWhen you use the remote for the first time, be sure to perform the following procedure. The remote is optimized for the receiver.
1Press RM SET UP.