Storing FM stations automatically
— AUTOBETICAL
(Models of area code CEL only)
This function lets you store up to 30 FM and FM RDS stations in alphabetical order without redundancy. Additionally, it only stores the stations with the clearest signals.
If you want to store FM or AM stations one by one, see “Presetting radio stations”.
1 Press ?/1 to turn off the receiver.
2 Hold down MEMORY/ENTER and press ?/1 to turn the receiver back on.
“Autobetical select” appears in the display and the receiver scans and stores all the FM and FM RDS stations in the broadcast area. For RDS stations, the tuner first checks for stations broadcasting the same program, then stores only the one with the clearest signal. The selected RDS stations are sorted alphabetically by their Program Service name, then assigned a
Regular FM stations are assigned 2- character preset codes and stored after the RDS station.
When done, “Autobetical finished” appears in the display momentarily and the receiver returns to the normal operation.
Notes
•Do not press any button on the receiver or supplied remote during autobetical operation, except ?/1.
•If you move to another area, repeat this procedure to store stations in your new area.
•For details on tuning the stored stations, see “Tuning to preset stations”.
•If you move the antenna after storing stations with this procedure, the stored settings may no longer be valid. If this happens, repeat this procedure to store the stations again.
Presetting radio stations
You can preset up to 30 FM or AM stations. Then you can easily tune in the stations you often listen to.
Presetting radio stations
1 Rotate INPUT SELECTOR to select tuner (“FM” or “AM”).
2 Press FM/AM to select “FM” or “AM”.
3 Tune in the station that you want to preset using Automatic Tuning (page 25) or Direct Tuning (page 26).
Switch the FM reception mode if necessary (page 25).
4 Press MEMORY/ENTER.
“MEMORY” appears in the display for a few seconds. Do steps 5 to 6 before the display goes out.
5 Press PRESET TUNING + or PRESET TUNING – to select a preset number.
If you want to switch the memory page, press SHIFT on the remote.
If “MEMORY” goes out before you select the preset number, start again from step 4.
6 Press MEMORY/ENTER again.
The station is stored to the selected preset number.
If “MEMORY” goes out before you press MEMORY/ENTER, start again from step 4.
7 Repeat steps 2 to 6 to preset another station.
Tuning to preset stations
1 Rotate INPUT SELECTOR to select tuner (“FM” or “AM”).
2 Press PRESET TUNING + or PRESET TUNING – repeatedly to select the preset station you want.
Operation Amplifier
continued