The measurement process will take approximately 30 seconds. Wait until the measurement process completes.
To cancel auto calibration, change the volume, activate the MUTING function, switch functions, change the setting of the SPEAKERS switch of the receiver, or connect headphones.
Note
You cannot measure the speaker height of the surround speakers and the surround back speakers. Set this value from “SP POSI.” settings in the Speaker settings menu.
Measurement starts.
6
“Auto Calibration” is displayed.
4 Press .
5 Press V/v repeatedly to select “AUTO CAL START?,” then press to start the measurement.
Measurement starts in five seconds. A count down is displayed.
Note
While the time is counting down, stand away from the measurement area to avoid measurement error.
Press MENU.
3
Press AMP.
Receiver operation is enabled.
2
Performing auto calibration
For details on the auto calibration, see “9: Calibrating the appropriate speaker settings automatically (Auto Calibration)” (page 46). Refer to “Before you perform the auto calibration” (page 46) before performing the auto calibration.
To operate on the receiver
1 Press SHIFT, then press MENU to switch from “GUI MODE” to “DISPLAY MODE.”

Tips

•Operations other than turning the receiver on or off are deactivated during auto calibration.

•In the following situations, the measurements may not be performed correctly or auto calibration cannot be performed.

–when special speakers, such as dipole speakers are used.

–when the multi zone function is used in zone 2.

To confirm/save auto calibration when GUI function is turned off1Confirm the measurement result.

When the measurement ends, a beep sounds and the measurement result appears on the display.

Measurement Display

Explanation

result

 

 

 

 

 

When the

COMPLETE

Proceed to step

measurement

 

2.

process

 

 

completes

 

 

properly

 

 

 

 

 

When the

ERROR

See “Message

measurement

CODE 3x

list after auto

process fails

 

calibration

 

 

measurement”

 

 

(page 51).

2Press V/v repeatedly to select the item,then press .

The measurement results are saved.

Item

Explanation

RETRY

Re-performs the auto

 

calibration.

 

 

SAVE EXIT

Saves the measurement

 

results and exits the setting

 

process.

 

 

WRN CHECK

Displays a warning

 

concerning the measurement

 

results. See “When you select

 

“WRN CHECK”” (page 51).

 

 

PHASE INFO

Displays the phase of each

 

speaker (in phase/out of

 

phase). See “When you select

 

“PHASE INFO””.

 

 

DIST.INFO

Displays the measurement

 

result for speaker distance.

 

 

 

continued

Operations Other

113GB