Sony STR-DA5300ES Tuner, 134GB, RDS does not work, The FM reception is poor, •Select a stronger FM station, Recording cannot be carried out, Radio stations cannot be tuned in

are output from the VIDEO jack. Input 480i component video signals.

•When component input signals other than 480p are output, use the COMPONENT VIDEO OUT jack and set “Resolution” to “DIRECT.”

Images of the source with HDMI connection is not output to the TV.•Make sure that cables are correctly and securely connected to components.

•Depending on the playback component, component may need to be set up. Refer to the operating instructions supplied with the each component.

•Be sure to use a connecting cable for the HDMI jack corresponding to high speed (an HDMI version1.3a, category 2 cable) when you view images or listen to sound during a DeepColor transmission.

Recording cannot be carried out.

•Check that the components are connected correctly (page 27).

•Select the source component using INPUT SELECTOR (page 53).

The GUI does not appear on the TV screen.•Press SHIFT, then press MENU to show “GUI MODE” on the display.•Check the TV is connected correctly.TunerThe FM reception is poor.

•Use a 75-ohm coaxial cable (not supplied) to connect the receiver to an outdoor FM antenna (aerial) as shown below. If you connect the receiver to an outdoor antenna (aerial), ground it against lightning. To prevent a gas explosion, do not connect the ground (earth) wire to a gas pipe.

Outdoor FM antenna (aerial)

Receiver

Ground (earth) wire (not supplied)

To ground

Radio stations cannot be tuned in.

•Check that the antennas (aerials) are connected securely. Adjust the antennas (aerials) and connect an external antenna (aerial), if necessary.

•The signal strength of the stations is too weak (when tuning in with automatic tuning). Use direct tuning.

•Make sure you set the tuning interval correctly (when tuning in AM stations with direct tuning).

•No stations have been preset or the preset stations have been cleared (when tuning by scanning preset stations). Preset the stations (page 84).

•Press DISPLAY so that the frequency appears on the display.RDS does not work.•Make sure that you are tuned to an FM RDS station.•Select a stronger FM station.The RDS information that you want does not appear.

•Contact the radio station and find out whether or not they actually provide the service in question. If so, the service may be temporarily out of order.

134GB