Sony STR-DA5300ES Tip, Note, Tips, Note, 49GB, Started Getting, 9 Measurement starts, To cancel the measurement, 2 Press to select “Next.”, 1 Confirm the measurement result

9 Measurement starts.

The measurement process will take approximately 30 seconds with a test tone. Wait until the measurement process completes.

Note

You cannot measure the speaker height of the surround speakers and the surround back speakers. Set the position of the surround speakers from “Position” in the Speaker settings menu.

Tips

•Operations other than turning the receiver on or off are deactivated during the measurement.

•In the following situations, the measurements have not been performed correctly or auto calibration cannot be performed.

–when connecting special speakers, such as dipole speakers.–when using the zone 2/zone 3 function in zone 2/ zone 3.To cancel the measurement

The measurement is cancelled when you change the volume, switch functions, change the setting of the SPEAKERS switch, or connect headphones.

Confirming/saving the measurement results1 Confirm the measurement result.

When the measurement ends, a beep sounds and the measurement result appears on the TV screen.

Note

When the speaker(s) is (are) out of the phase, “Out Phase” is displayed on the TV screen. The “+” and “–” terminals of the speaker may be connected the other way around. However, depending on the speakers, “Out Phase” appears on the TV screen even though the speakers are connected properly. This is because of the speakers’ specifications. In this case, you can continue to use the receiver.

Tip

The displayed unit of distance for models for US and Canada is feet. The unit of distance for models for countries/areas other than US and Canada is meters. You can change the unit of distance use in “Distance Unit” in the Speaker settings menu.

2 Press to select “Next.”

When “Save auto calibration (auto speaker setup) results?” appears on the TV screen, you can select whether to confirm the warning (“Yes”) or not (“No”).

Follow the instructions of the TV screen when you select “Yes.”

For details on warning and error codes, see “Message list after auto calibration measurement” (page 51).

continued

49GB

Started Getting