Sony STR-DB1070, STR-DB870 manual 15

S-LINK CONTROL S hookup

(Models of area code U, CA only)

If you have a S-LINK CONTROL S- compatible Sony TV, satellite tuner, monitor, DVD player or VCR, use an audio/video/ control S connecting cord (supplied) or a control S connecting cord (supplied) to connect the CTRL S (STATUS) IN (for TV, satellite tuner, or monitor) or OUT (for VCR, etc.) jack on the receiver to the appropriate S-LINK jack on the respective component. Refer to the operating instructions supplied with your TV, satellite tuner, monitor, VCR, etc., for details.

The following illustration is an example of S-LINK CONTROL S hookups between the receiver, a TV, a VCR, and a DVD player. When your TV is connected to the receiver as shown below, the TV input mode will change to video input whenever you turn on the receiver. When you connect the receiver as shown below, input mode of the receiver changes to VIDEO 1 or DVD/LD whenever you play your VCR or DVD.

The following connections also change the input mode of the receiver to TV whenever you operate your TV.

TV	S-LINK
	OUT IN

AUDIO

OUT

VIDEO

IN

HG*

Receiver	IN	STATUS IN	OUT	OUT
	CTRL S	CTRL S	CTRL S	CTRL S
	S-VIDEO	S-VIDEO	S-VIDEO	S-VIDEO S-VIDEO
	OUT	IN	IN	OUT	IN
	VIDEO	VIDEO	VIDEO	VIDEO	VIDEO
	MONITOR	AUDIO	AUDIO	AUDIO	AUDIO
		IN	IN	OUT	IN
		TV/SAT	DVD/LD	VIDEO 1
					G
VCR 1				OUTPUT	S-LINK
				OUT	IN
				VIDEO
				AUDIO
				OUT
			G
DVD			OUTPUT
			OUT
			VIDEO
player		S-LINK	AUDIO
		IN
			OUT

*Pull the video cord away from the supplied audio/ video/control S cable.

Note
Refer to the operating instructions supplied with your
TV for details regarding the operations you can	Hooking
control from your TV.

2ND ROOM hookup

(STR-DB1070 only)	Up
You can use the 2ND ROOM OUT jacks to
	the
output the audio signals of the selected
component to a stereo amplifier located in	Components
If your receiver has a voltage selector on the
another room (see page 27).
Setting the voltage selector
rear panel, check that the voltage selector is set
to the local power supply voltage. If not, use a
screwdriver to set the selector to the correct
position before connecting the AC power cord
to a wall outlet.

VOLTAGE SELECTOR

220V

240V

120V

continued

15