Press SET UP.

Tip

You can freely specify the time. After pressing

SLEEP, specify the time you want using the jog dial

and cursor buttons ( or ) on the receiver. The sleep time changes in 1 second intervals. You can specify up to 5 hours.

To check the remaining time before the receiver turns off, press SLEEP. The remaining time appears in the display.

Adjustments using the

SET UP button

The SET UP button allows you to make the following adjustments.

1

2 Press the cursor buttons ( or ) to select the parameter you want to adjust.

3 Turn the jog dial to select the setting you want.

The setting is entered automatically.

4 Repeat steps 2 and 3 until you have set all of the parameters that follow.

Initial settings

Parameter

Initial setting

6.1CH DECODING

AUTO

 

 

MULTI CH (1 or 2)

NONE

 

 

D.POWER

ALWAYS ON

 

 

V.POWER

AUTO OFF

 

 

S.FIELD LINK

ON

 

 

A1 AUTO POWER

ON

 

 

AUTO FUNCTION

ON

 

 

2ND ROOM SP1)

OFF

COMMAND MODE2)

AV1

COLOR SYSTEM3)

PAL

OSD4)

COLOR

OSD H.POSITION4)

4

OSD V.POSITION4)

4

1)Only when the center or surround back speaker is set to “2ND ROOM” (STR-DB1070 area code U, CA only).

2)Except for STR-DB870 area code CEL.

3)STR-DB1070 of area code other than U, CA only.

4)STR-DB1070 only.

x6.1ch Matrix (6.1CH DECODING)

You can set this parameter using 6.1CH DECODING on the front panel.

When set to “AUTO”, the receiver performs

6.1channel matrix decoding only if 6.1 channel signals decode flag is ON.

When set to “ON”, the receiver performs

6.1channel matrix decoding only if the surround signals are 2 channel, regardless of the

6.1channel decode flag.

When set to “OFF”, the receiver does not perform 6.1 channel matrix decoding.

During “A.F.D.”, this parameter is always set to “AUTO”, and you cannot change the setting.

When the 6.1 channel matrix decoding is performed and the surround back speaker is set to “NO”, you can enjoy the surround back signals with virtual 3D technology, even without an actual surround back speaker (the box around SB does not light up). If the surround back speaker is set to “YES”, the surround back signals are output through the actual speaker (SB and the box lights up).

(For STR-DB870) Please note that you can set the surround back speaker only when the center speaker is set to “NO” (page 20).

xMulti channel assignment (MULTI CH (for STR-DB1070, MULTI CH 1 or 2))

Lets you assign a function to MULTI CH (for STR-DB1070, MULTI CH 1 or 2). You cannot assign TUNER or PHONO.

For STR-DB1070, you cannot assign the same function to both MULTI CH 1 and 2.

continued

Operations Other

45