After connecting all the components, speakers and AC power cord, output a test tone to check that all the speakers are connected correctly. For details on outputting a test tone, refer to ”Adjusting the speaker volume”, on page 20.

If you have connected rear speakers, be sure to press the 5.1 CH/DVD button and turn off sound field on the receiver before outputting a test tone so that the tone is output individually from the left and right rear speakers.

If no sound is heard from a speaker while outputting a test tone or a test tone is output from a speaker other than the one whose name is currently displayed on the receiver, the speaker may be short-circuited. If this happens, check the speaker connection again.

Active woofer

Receiver

Active Woofer

SUB

 

WOOFER

INPUT

AUDIO OUT

 

Note

Do not connect any other component.

To listen to the speakers

Make sure that you set the SPEAKERS button to ON.

If your TV monitor uses separate speakers

You can connect one of them to the SPEAKERS CENTER terminals for use with Dolby Pro Logic Surround sound (see page 19).

Where do I go next?

To complete your system, go to “AC Hookups” on this page.

Getting Started

AC HookupsConnecting the mains lead

Connect the mains lead from this receiver and from your audio/video components to a wall outlet.

,

to a wall outlet

Where do I go next?

Before you use the receiver, go to the next section to make sure that all the controls are set to the appropriate positions.

9GB