Performing initial setup
operations
Once you have hooked up the speakers and turned on the power, clear the receiver’s memory. Then specify the speaker parameters (size, position, etc.) and perform any other initial setup operations necessary for your system.
Tip
To check the audio output during settings (to set up while outputting the sound), check the connection (page 22).
Clearing the receiver’s memory
Before using your receiver for the first time, or when you want to clear the receiver’s memory, do the following.
1 Turn off the receiver.
2 Hold down ?/1 for 5 seconds.
“PUSH” and “ENTER” appears in the display alternatingly.
3 Press ENTER.
After “CLEARING” appears in the display for a while, “CLEARED” appears.
The following are reset to their factory settings.
•All settings in the SET UP, CUSTOM, LEVEL and EQ menus.
•The sound field memorized for each input selector and preset station.
•All sound field parameters.
•All preset stations.
•All index names for input selector and preset stations.
•The master volume is set to “VOL MIN”.
Performing initial setup operations
Before using your receiver for the first time, adjust SET UP parameters so that the receiver correspond to your system. For the adjustable parameters, see the table on page 62. See pages
Multi channel surround
setup
For the best possible surround sound, all speakers should be the same distance from the listening position (A).
However, the receiver lets you place the center speaker up to 1.5 meters closer (B), the surround speakers up to 4.5 meters closer (C) and the surround back speaker up to 4.5 meters closer (D) to the listening position.
The front speakers can be placed from 1.0 to 7.0 meters from the listening position (A).
You can place the surround speakers either behind you or to the side, depending on the shape of your room (etc.).
When placing surround speakers to your side
(long room)
| B |
A | A |
| 45° |
C | C |
| 90° |
D20°
continued
Up Hooking
Setting and the Up System Speaker