5 Repeat steps 1 to 4 to control other components.
To cancel programming
Press USE MODE during any step. The remote automatically exits the programming mode.
To activate the input source after programming
Press the programmed button to activate the input source you want.
If programming is unsuccessful, check the following:
•If the indicator does not light up in step 1, the batteries are weak. Replace both batteries.
•If the indicator flashes 4 times in quick succession while entering the numeric code, an error has occurred. Start again from step 1.
Notes
•The indicator turns off while a valid button is pressed.
•In step 2, if several input selector buttons are pressed, only the last pressed button is valid.
•In step 2, if you press TV ?/1, only TV VOL
•In step 3, if an input selector button is pressed, the new input source is selected and the programming procedure returns to the beginning of step 3.
•For the numeric codes, only the first three numbers entered are valid.
To clear the memory of the remote
To clear all programmed and learned signals, do the following to reset the remote to factory settings.
Press ?/1, AV ?/1 and MASTER VOL – at the same time.
The indicator flashes 3 times, then goes off.
The numeric codes corresponding to the component and the maker of the component
Use the numeric codes in the tables below to control
Notes
•The numeric codes are based on the latest information available for each brand. There is a chance, however, that your component will not respond to some or all of the codes.
•All of the input selectors on this remote may not be available when used with your particular component.
To control a CD player
Maker | Code(s) |
SONY | 101, 102, 103 |
|
|
DENON | 104, 123 |
|
|
JVC | 105, 106, 107 |
|
|
KENWOOD | 108, 109, 110 |
|
|
MAGNAVOX | 111, 116 |
|
|
MARANTZ | 116 |
|
|
ONKYO | 112, 113, 114 |
|
|
PANASONIC | 115 |
|
|
PHILIPS | 116 |
|
|
PIONEER | 117 |
|
|
TECHNICS | 115, 118, 119 |
|
|
YAMAHA | 120, 121, 122 |
|
|
continued
Using Operations Remote the