Changing the factory setting of an INPUT SELECTOR button
If the factory settings of the INPUT SELECTOR buttons do not match your system components, you can change them. For example, if you have an MD deck and a tape deck and you don’t have a CD player, you can assign the CD/SACD button to your tape deck.
Note that the settings of the TUNER button cannot be changed.
1 Hold down the INPUT SELECTOR button whose input source you want to change (for example, CD/SACD).
2 Press the corresponding button of the component you want to assign to the INPUT SELECTOR button (for example, 4 – Tape deck).
The following buttons are assigned to select the input source:
To operate | Press |
CD player | 4 |
|
|
MD deck | 5 |
|
|
Tape deck A | 6 |
|
|
Tape deck B | 7 |
|
|
LD player | 8 |
|
|
VCR (command mode VTR 1*) | 9 |
|
|
VCR (command mode VTR 2*) | 0 |
|
|
VCR (command mode VTR 3*) | >10 |
|
|
TV | ENTER |
|
|
DSS (Digital Satellite Receiver) | . |
|
|
DVD | > |
|
|
*Sony VCRs are operated with a VTR 1, 2 or 3 setting. These correspond to Beta, 8mm and VHS respectively.
Now you can use the CD/SACD button to control the tape deck.
To change the factory settings of VIDEO 3 and AUX buttons
1 Hold down FN SHIFT and the INPUT SELECTOR button you want to change (for example, VIDEO 3 or AUX).
2 Press the corresponding button of the component you want to assign to the INPUT SELECTOR button.
To reset a button to its factory setting
Repeat the above procedure.
To reset all the INPUT SELECTOR buttons to their factory setting
Press ?/1, AV ?/1and MASTER VOL – at the same time.
Using Operations Remote the