Setting remote control codes that are not stored in the remote
When a remote control code is not one of the presets stored in the remote, it is possible for the remote to learn the code using the Learning function.
1Press SLEEP while pressing down USE MODE.
The indicator lights.
2Press the function button for the component you want to learn functions for.
For example, if you are going to learn an operation for a CD player, press CD.
3Press the button you want to use for the Learning function.
The indicator turns off while a valid button is pressed, then blinks slowly.
4Point the remote control code receiver section of the remote toward the receiver/transmitter on the remote control to be learned.
n | m |
N | M |
X | . |
x | > |
5Press the appropriate button on the remote control to be learned to send the remote button code.
Lightly pressing the button once should be sufficient. If learning is completed successfully, the indicator slowly flashes twice and the remote automatically exits the learning mode.
When learning is not completed successfully, the indicator flashes 4 times in quick succession and the procedure returns to step 5.
If the memory of the remote is already full, the indicator flashes 8 times in quick succession and the remote automatically exits the learning mode.
Notes
•You can program up to 80 buttons for the Learning function. In some cases, you may not be able to program even if you have not programmed 80 buttons.
•In steps 2 and 3, the indicator turns off while a valid button is pressed.
•In step 3, if several buttons that can be used for learning are pressed, only the last pressed button is valid.
•In step 5, if a button that can be used for learning is pressed, the new button is selected and the learning procedure returns to the beginning of step 5.
•You can use TV/VIDEO only for the MONITOR function.
zTo activate the function after programming.
Press the programmed button to activate the function you want.
To cancel learning
Press USE MODE during any step. The remote automatically exits the learning mode.
To clear the learned codes
Start over from step 1. After step 3, press SLEEP for more than 2 seconds. The indicator lights twice slowly and the learned code is cleared. If SLEEP is pressed less than 2 seconds, the learning procedure returns to the beginning of step 5.
When a learned code is cleared, if the button was previously programmed for another function, the programmed code for that button can be used.
To clear the memory of the remote
To clear all programmed and learned signals, do the following to reset the remote to factory settings.
At the same time, press ?/1, AV ?/1, and MASTER VOLUME.
The indicator flashes 3 times, then goes off.
To use a command that has been learned
When selecting a learned function, press the learned button for that function.
Information Additional
69