Information Additional

Remote Button Description

Performing several commands in

sequence automatically (Macro Play)

The Macro Play function lets you link several IR codes in a sequential order as a single command. The remote provides 2 macro lists (MACRO1 and 2). You can specify up to 10 IR codes for each macro list.

Setting the sequence of IR codes

1Press MACRO1 (or MACRO2) while pressing down

USE MODE.

The indicator lights.

2Press the numeric buttons to select the macro step number.

For example, to program step 1, press 1.

3Press the button you want to program.

To program the operation (IR code) of a component connected to the receiver, press the function button (including MONITOR) first, then press the button for the operation.

For example, to play the CD player, press CD, then press H.

When programmed successfully, the indicator lights twice slowly, then the remote automatically exits the macro setting mode.

To program the operation (IR code) of the receiver, press the button for the operation.

Buttons that can be programmed:

SLEEP, ?/1, 2ND ROOM, A.F.D., MODE +/–, 2CH,

PRESET, TEST TONE, NIGHT MODE, EQ, MULTI/ 2CH A. DIRECT, ON SCREEN, MUTING, MAIN MENU, MASTER VOL +/–

When programmed successfully, the indicator lights twice slowly, then the remote automatically exits the macro setting mode.

4Repeat steps 1 through 3 to program up to 10 IR codes.

Tips

•To program a function switch, press the same function button twice in step 3.

•If programming is unsuccessful, check the following:

–If the indicator does not light up in step 1, the batteries are weak. Replace both batteries.

–If the indicator lights 4 times in quick succession in step 3, an error has occured. Start again from step 1.

Note

The indicator turns off while a valid button is pressed.

To cancel programming

Press USE MODE during any step. The remote automatically exits the macro setting mode.

To delay the output of an IR code

Start over from step 1. In step 3, press VIDEO 1, then MACRO1 or MACRO2. This allows you to specify 1 second delay before output the next IR code. Be sure not to press MACRO1 or MACRO2 for more than 2 seconds.

To clear the programmed IR codes

Clear each macro step individually.

1Press MACRO1 or MACRO2 (in which the IR code you want to clear is programmed) while pressing down USE MODE.

2Press the numeric button to select the macro step number you want to clear.

3Press VIDEO 1.

4Hold down MACRO1 or MACRO2 for more than 2 seconds.

The IR code is cleared. The indicator lights twice slowly, then the remote automatically exits the macro setting mode.

To start macro play

Press MACRO1 (or MACRO2).

Note

If the Macro Play function does not work properly, program a delay between each operation. See “To delay the output of an IR code”.

70