The display changes cyclically as follows: OFF (sleep mode disabled) t 2:00:00 (shutdown in two hours) t 1:30:00 (shutdown in one and a half hour) t 1:00:00 (shutdown in one hour) t 0:30:00 (shutdown in half an hour)
When using the Sleep Timer, SLEEP appears on the display.

Recording audio

Make sure that all your components are correctly connected before recording audio.

Recording audio on MD, tape, or hard disk

You can use the receiver to record audio on mini disks (MD), tapes, or to your hard disk with the appropriate software. For details about how to perform this procedure, refer to the documentation of your MD player, tape player, or audio recorder.

1 Press INPUT SELECTOR to select a connected component (programme source).2 Prepare the selected component for recording.

For example, insert a VCD into your VCD player.

3 Insert an MD or tape into the audio recording device, and adjust the recording level.

4 Start recording on the audio recording device, and then start playback.

Notes

•Audio adjustment does not affect the signal output from the HDD/MD OUT jack of the receiver.

•You cannot record signals using copy-protection technology.

•You cannot output audio input to a digital input jack to an analogue output jack. Connect to an analogue input jack.

•You cannot record audio played back with Network Media.

Using the Sleep Timer

You can set the receiver to turn off automatically at a specific time by using the remote.

1 Press the black MAIN MENU button repeatedly until SET UP appears on the display.

2 Press / to select OFF.

3 Press / to select the time.

Tip

To check the remaining time before the receiver turns off, perform steps 1 and 2 above. The remaining time appears on the display.

48GB