Manual tuning

You can tune in stations in 50 kHz steps for the FM band and 9 kHz steps for the AM band.

1 Press the FM or AM button repeatedly to select the FM or AM band.

You can also use INPUT SELECTOR on the system. The last station received is tuned in.

2 Press the TUNING MODE button repeatedly to select MANUAL T..

3 Press the TUNING + or TUNING – button repeatedly to tune in the station that you want.

Press the TUNING + button to change the frequency from low to high.

Press the TUNING – button to change the frequency from high to low.

Tip

If STEREO flashes on the display and the FM stereo reception is poor, press the FM MODE button to improve the sound. You will not be able to enjoy the stereo effect, but the sound will be less distorted.

Note

If STEREO does not appear at all when an FM broadcast is received normally, press the FM MODE button to display the STEREO indication.

Preset tuning

After you have tuned in stations using automatic tuning or manual tuning, you can preset them to the receiver. You can then tune in any of the preset stations directly. Up to 30 FM or AM stations can be preset. The receiver also scans all the stations that you have preset.

Before tuning in preset stations, be sure to preset them by performing “Presetting radio stations”.

Presetting radio stations

1 Press the FM or AM button repeatedly to select the FM or AM band.

You can also use INPUT SELECTOR on the system. The last station received is tuned in.

2 Tune in the station that you want to preset using automatic tuning or manual tuning (page 37).

3 Press the MEMORY button.

MEMORY appears on the display for a few seconds.

Perform steps 4 to 5 before MEMORY disappears.

4 Press the SHIFT button to select the memory page and press the PRESETCH/ALBUM + or PRESET CH/ALBUM – button to select a preset number.

If MEMORY disappears before you press the preset number, return to step 3.

5 Press the MEMORY button again to store the station.

If MEMORY disappears before you can store the station, return to step 3.

6 Repeat steps 2 to 5 to preset another station.Tuning in preset stations

1 Press the FM or AM button repeatedly to select the FM or AM band.

You can also use INPUT SELECTOR on the system. The last station received is tuned in.

2 Press the PRESET CH/ALBUM + or PRESET CH/ALBUM – buttonrepeatedly to select the preset station that you want.

Each time that you press the button, the receiver tunes in one preset station at a time, in the corresponding order and direction as follows:

tA1yA2y...yA0yB1yB2y...yB0T

tC0y...yC2yC1T

Tips

•In step 2, press the SHIFT button to select a memory page (A, B, or C).

•You can also use the PRESET TUNING +/– buttons on the receiver to tune in preset stations.

38GB