Step 3: Connecting the AC power cord

Connect the AC power cord of the receiver to the power outlet.

AC power cord

To power outlet

Initial setup

Before using the receiver for the first time, initialise the receiver by performing the following procedure.

This procedure can also be used to return the settings that you have made to their defaults.

1 Press the ?/1 button on the receiver to turn it off.2 Hold down the ?/1 button for 5 seconds.

The following items are reset or cleared when INITIAL appears on the display:

All the sound field parameters are reset to their defaults.

All SET UP, LEVEL, and TONE parameters are reset to their defaults.

The sound fields memorised for each programme source and preset stations are cleared.

The master volume is set to VOL MIN.

Step 4: Inserting batteries into the remote

Insert two R6 (size AA) batteries with the + and

– properly oriented in the battery compartment.

Tip

Under normal conditions, the batteries should last about six months. When the remote no longer operates the control centre, replace both batteries with new ones.

Notes

Do not leave the remote in an extremely hot or humid place.

Do not use a new battery with an old one.

Do not expose the remote sensor of the control centre to direct sunlight or lighting equipment. Doing so may cause malfunctions.

If you do not use the remote for an extended period of time, remove the batteries to avoid possible damage from battery leakage and corrosion.

Turn off the power to all components before making any connections.

Be sure to make connections firmly to avoid hum and noise.

18GB