Sony STR-LV700R Step 1: Verifying the connection procedure for your type of output devices, — Preparing the receiver, Preparations, A Audio cable, B Video cable

— Preparing the receiver

This section describes how to set up the receiver before using it.

Step 1: Verifying the connection procedure for your type of output devices

Specific connection procedures for your output devices are explained in steps 1a, 1b, and 1c. Refer to the table below to proceed.

Output device list

Output device		Pages
DVD player	With digital output jacks1)	10
	With analogue output jacks only2)	14
Television		14
Satellite tuner	With digital output jacks1)	10 – 11
	With analogue output jacks only2)	13 – 14
MD deck/tape deck	With digital output jacks1)	12
	With analogue output jacks only2)	13
VCR		14
Antennae		15

1)When your device comes with jacks such as digital optical output or digital coaxial output jacks.

2)When you device only comes with jacks such as audio out L/R jacks.

Before you get started

The connection diagrams on the subsequent pages assume the use of the following optional cables (A to D).

A Audio cable	C Optical digital cable
White (L)
Red (R)	D Coaxial digital cable
B Video cable
Yellow

Notes

•Turn off the power to all components before making any connections.

•Be sure to make connections firmly to avoid hum and noise.

•Connect the yellow connector of the video cable to the VIDEO IN jack of the receiver.

•Connect the red connector of the audio cable to the AUDIO IN R jack, and the white connector to the AUDIO IN L jack of the receiver

•When connecting optical digital cables, insert the cable plugs straight in until they click into place.

•Do not bend or tie optical digital cables.

Preparations

9GB