Step 3:

Preparing for the installation of the TV

If you intend to install a TV that is not specified on page 2, be sure to refer to the leaflet supplied with your TV.

For KDL-46X3500, KDL-46X3000, KDL-46W3000, KDL- 46V3000, KDL-40X3500, KDL-40X3000, KDL-40W3000, KDL-40V3000 users, the procedures for adjusting the position of the Support Frame are not necessary. Follow from part 3 of this Step.

1 Detach the Beam and the Support Frame.

Beam

Support Frame

Support Base

Note

Be careful not to drop the Beam and the Support Frame when detaching them.

2 Adjust the position of the Support Frame.

A

For KDL-52X3500, KDL-52W3000

1Attach the Support Frame to the Support Base matching the holes of the Support Frame to the pins

of the Support Base, and secure the eight screws removed in part 1, as shown in the illustration.

2Align hole “B” of the Beam and hole “B” of the Support Frame and secure with the four screws which were removed in part 1.

Beam

Support Frame

Support

Base

Pin

B

For KDL-52X2000, KDL-46X2000, KDL- 40X2000

1Reverse the Support Frame to make the “Y” marking face front. Then attach the Support Frame to the Support Base matching the holes of the Support Frame to the pins of the Support Base, and

secure the eight screws removed in part 1, as shown in the illustration.

2Align hole “C” of the Beam and hole “C” of the Support Frame and secure with the four screws which were removed in part 1.

Beam

Support Frame

Support

Base

Pin

Note

When using an electric screwdriver, set the torque setting to approximately 1.5 N·m {15 kgf·cm}.

(Continued)

7 (GB)