Step 2:Assembling the FloorStand

WARNING

If you allow the AC power cord to be pinched under or between pieces of equipment, this may result in a short circuit or an electric shock. If you stumble over the AC power cord or the connecting cable, the Floor Stand may topple over and cause injury.

Decide on the installation location and lay the Floor Stand down before installing the TV.

Since the TV is heavy, it is recommended that you decide on the installation location beforehand, and assemble the Floor Stand on site.

1 Detach the Front and Rear PillarSupport Panels from the CenterPillar.

Rear Pillar

Support Panel

Front Pillar

Support Panel

2 Attach the Center Pillar to the Frame.

Match the screw holes of the Frame and the “F” marks of the Center Pillar and secure them with the four supplied screws (+PSW5 × L25).

Screw Frame (+PSW5 × L25)

Notes

Be sure that two or more persons assemble the Floor Stand.

Loosely attach the Center Pillar to the Frame with the four screws, then tighten all screws sufficiently.

When using an electric screwdriver, set the torque setting to approximately 1.5 N·m {15 kgf·cm}.

3 Attach the Front Pillar Support Panel.

Note

Before attaching the Front Pillar Support Panel, check that the four screws are firmly tightened.

6 (GB)