Be sure to set the spacer according to the size of the paper before placing the paper in the paper tray.
Reverse side with printed logos
Print surface protection
Riffle the paper. sheet
Place the paper in the paper tray with the printing surface (shiny side with no legends) and its protection sheet facing down.
Tab
Tab
3 Close the tray cover and slide the paper tray into the printer until it clicks into place.
Notes on storing paper
•Avoid storing the paper in a location subject to:
–high temperatures
–high humidity
–excessive dust
–direct sunlight
•Use the original package for storing unused paper.
Operation
When using the
When using the UPC- 771 (letter size): Pull up the tab, bring the spacer to the “LETTER” position, and then push the tab down there.
Notes
The number of the paper is the same as the number of the paper that one roll of the ink ribbon can afford. Usually the ink ribbon and paper have run out at the same time. However, even when either the ink ribbon or the paper has run out, replace both the ink ribbon and the paper with new ones. When you load the paper, pay attentions to the following.
•The paper tray holds up to the total number of sheets contained in a package sheets of paper. If you exceed this limit, paper jams may occur. Also, do not place different types of paper in the tray. If you do, paper jams may occur.
•If you load the paper that is not compatible with the ink ribbon used, the gray balance may be changed.
•Load the paper so that it lays flat in the paper tray. If the paper is curled, it will overflow the paper tray and the printing position may shift. If this happens, load fewer sheets in the paper tray.
Before Printing 11