Introduction

Location and Function of Parts and Controls

For details, refer to the pages indicated in parentheses.

Front

A!POWER switch

Press to turn the printer on or off.

BFan cover (7, 18)

Provided to prevent the printer from dust.

CRibbon door (9)

Pull the tab (marked with PULL) on the top on the ribbon door to open it when loading an ink ribbon cassette.

DPrinter window display (12)

Displays the status messages. In menu operation, menu items are displayed.

If an error occurs, a corresponding error message is displayed.

EALARM indicator (21)

Lights in orange when the ink ribbon or paper is exhausted, the paper jams, or another problem occurs.

FCursor control buttons (13)

Use these buttons to increase or decrease a value and level shown on the menu, or scroll up and down through a menu.

GMENU button (13)

Press this button to display or close the printout adjust menu in the printer window display.

HEXEC button (13)

Use this button in menu operation.

IPaper cover (7) Printouts are ejected here.

JPaper tray (7, 10)

Load paper here. Press the point marked with PUSH to remove the paper tray.

Rear

ANetwork connector (RJ-45 modular jack) (8) Conforms to the 100BASE-TX standard. Used to connect to the LAN.

When using a LAN cable:CAUTION

For safety, do not connect to the connector for peripheral device wiring that might have excessive voltage.

B Equipotential ground terminal connector Used to connect to a ground (equipotential) plug to bring the various parts of the system to the same potential.

Refer to “Important safeguards/notices for use in the medical environments” on page 2.

C-AC IN connector (8)

Use a proper power cord for your local power supply (not supplied).Refer to “Warning on power connection” on page 3 and “Warning on power connection for medical use” on page 3.

6 Location and Function of Parts and Controls