Notes on the European model

The reception channels are divided into four sets.

Select the group number before selecting the channel number as follows.

1)While the left two digits are flashing, select the group number by pressing the + or – button.

2)When the desired group number appears, press the SET button.

The right four digits start to flash to allow the selection of the channel number.

3)Select the channel number by pressing the + or – button.

Group Channel Frequency selection selection selection

V : + button v : – button

Group, channel, and frequency selection examples for CE62 model are shown.

4 When the desired channel number (or frequency) appears, leave the tuner for about 10 seconds until the selected channel number (or frequency) stops flashing and the selection is stored in memory.

Notes

•When you are setting the reception channel, the tuner can be used to receive signals.

•Do not remove the batteries while setting the reception channel. If they are inadvertently removed, re-insert them immediately and redo the procedure “Setting the reception channel” from step 1.

•Make sure that the selected channel is the same on the transmitter and tuner being used in the same system.

•If you turn off the tuner and then immediately turn it on right after setting the reception channel, the unit may not operate normally. Wait a few seconds before turning it on again.

Setting the attenuationlevel of the audio input

The procedure below is the same for all UWP series transmitters (UTX-B1/H1).

The attenuation level can be set during signal transmission.

1 Do the following while there is no signal transmission. Turn on the transmitter while pressing down the SET button, and press the SET button repeatedly until the attenuation level indication appears in the display section.

39