Settings

Do the following while there is signal transmission. Press the SET button repeatedly until the attenuation level indication appears in the display section.

2 Press the + or – button to select the attenuation level.

The selectable range is from 0 dB to 21 dB in steps of 3 dB (the factory setting is 0 dB).

3 Do the following while there is no signal transmission. Set the POWER switch to OFF to complete the setting, or press the SET button to set other items. The results are stored in memory. The change becomes effective the next time you turn on the transmitter by setting the POWER switch to ON.

Resetting the accumulated battery use time indication

The procedure below is the same for all UWP series transmitters (UTX-B1/H1) and the portable diversity tuner (URX-P1).

The accumulated battery use time is the total time (in hours and minutes) that the batteries have been used. It is recorded whenever the transmitter/ microphone/tuner is on.

Reset the indication to “00:00” whenever you replace the batteries.

1-aFor transmitters (UTX-B1/H1)Turn on the unit while pressing down the SET button.

1-bFor the portable diversity tuner (URX-P1)

Press down the SET button for more than one second.

Keep pressing the SET button until the display section parameters start to flash.

2 Press the SET button repeatedly until the accumulated time indication appears in the display section.

3 Press the – button.

The time indication resets to “00:00.”

While “00:00” is still displayed, you can return to previous value by pressing the + button.

4-aFor transmitters (UTX-B1/H1)Set the POWER switch to OFF to complete the setting, or press the SET button to set other items. The results are stored in memory.

40