7 Press /and ENTER to set the playback content.

If you select [Yes], the currently playing content is played when turned on by the On-Timer.

If you select [No], the content that you set last time is played.

8 Press VOLUME +/- to adjust the playback volume, and then press /and ENTER to set the volume.

If you select [Yes], the current volume is set when turned on by the On-Timer.

If you select [No], the volume you set last time remains set.

“Confirm On-Timer settings” appears.

9 Press /to select [OK], and then press ENTER.

The On-Timer is set and appears on the playback screen.

Three minutes prior to the time you set, this device prepares for the On-Timer playback.

Tips

If you do not want to set the Finish Time, set it to [--:--].

When you are setting the On-Timer in PC Streaming Function or in Internal Memory Function, the playback mode changes temporarily to [1 Repeat]. After completing the setting, it is restored.

If the specified content has been deleted before the On-Timer playback starts or if the content cannot be found, an alarm sounds at the start time. Press any buttons to stop the alarm.

If the time periods for the timer1 and timer2 overlap, the timer that is set to start earlier overrides the later one.

Notes

You cannot use the On-Timer function in Auxiliary Function.

If you fully shut down this device (page 31), the On-Timer settings are reset.

If this device has already been turned on before three minutes from the start time of the On-Timer, the On-timer is not activated.

Operation

43