Message Lists

Warning messages

Message

Cause and Remedy

 

 

 

 

 

 

High temp.! Lamp off in 1

 

c Turn off the power.

 

min.

 

c Check to ensure that nothing is blocking the ventilation holes.

 

 

(1 page 13)

 

 

 

 

 

Frequency is out of range!

 

c Frequency is out of range. Input a signal that is within the

 

 

acceptable frequency range of the projector.

 

 

 

 

 

 

Please check Input-A

 

c Set “Input-A Signal Sel.” in the Setup

menu to

Signal Sel.

 

“Computer” when an RGB signal is input from a computer.

 

 

(1 page 47)

 

 

 

 

 

Please replace the Lamp/

 

c It is time to replace the lamp. Replace the lamp. (1 page 55)

Filter.

 

c Also, replace the air filter too. Restart cleaning the Ventilation

 

 

holes (intake). (1 page 55)

 

 

 

If this message appears again after you replace the lamp and

 

 

filter, the lamp replacement process is not complete. Check the

 

 

lamp replacement process. (1 page 55)

 

 

 

 

 

 

 

 

Note

 

 

To clear this message, press any button either on the remote control

 

or the control panel of the projector once.

 

 

 

 

 

Please replace the filter.

 

c It is time to replace the air filter. Replace the air filter. (1 page

 

58)

 

 

 

 

 

 

Please replace the filter.

 

c It is time to replace the air filter. Replace the air filter. (1 page

Have you finished? Yes No

58)

 

 

 

 

c If you replaced the air filter, select “Yes.” If you did not replace

 

 

the air filter, select “No.”

 

 

 

 

 

Projector temperature is

 

c Check to ensure that the Ventilation holes on the unit are not

high. Cooling Setting

 

covered. (1 page 13)

 

should be “High” if

 

c When using the projector at high altitude, set the Cooling

projector is being used at

 

Setting to “High”. (1 page 46)

 

high altitude.

 

 

 

 

 

Note

 

 

 

 

 

 

 

When temperature inside the projector remains high, the Cooling

 

Setting is switched to “High” in 1 minute, then the fan speed

 

increases.

 

 

 

 

 

 

Caution messages

Message

Cause and Remedy

 

 

x

c No signal is input in the selected input. Check connections.

 

(1 page 17)

 

 

Not applicable!

c Press the appropriate button.

 

c The operation to be activated by the button is currently

 

prohibited.

 

 

54