Message

PC

PJ

Cause and Remedy

 

 

 

 

Unable to switch

a

 

• When the screen resolution of the computer is not

resolution of PC desktop.

 

 

identical with the projector LCD panel resolution, and

 

 

 

when the computer is connected to the projector with

 

 

 

[Set PC desktop to Projector resolution] of the [Option

 

 

 

Setting]-[Connection Setting] checked, the resolution

 

 

 

switching of the computer cannot be done successfully.

 

 

 

c If the message appears every time the computer is

 

 

 

connected to the projector, uncheck [Set PC desktop to

 

 

 

Projector resolution].

 

 

 

 

LAN Module with same

a

 

• The IP address on the same subnet mask which is used

network address exists.

 

 

by the LAN module for the network has been assigned

 

 

 

to another LAN module.

 

 

 

c Check the IP Address Setting of the LAN module used

 

 

 

with the Projector Station for Air Shot Version 2 and

 

 

 

that used in the computer. Then change the settings so

 

 

 

that their network addresses are not identical.

 

 

 

 

LAN Module

a

 

• While the computer is connected to the projector, the

disconnected while

 

 

LAN module is removed.

connecting.

 

 

c If the USB or LAN module of PCMCIA is removed

 

 

 

during connection, the computer may become unable to

 

 

 

establish proper connection with the projector. To

 

 

 

remove the USB or LAN module of PCMCIA, make

 

 

 

sure to disconnect the device.

 

 

 

 

System error/Quit

a

 

• Because of the lack of system resources in the computer,

Projector Station for Air

 

 

you cannot start the Projector Station for Air Shot

Shot Version 2

 

 

Version 2 properly.

 

 

 

c Restart Windows and start the Projector Station for Air

 

 

 

Shot Version 2.

 

 

 

 

The same IP Address

a

a

• The set IP address is already in use.

already exists.

 

 

c Input a new IP address.

 

 

 

 

Projector connection

a

 

• The network condition is not good.

error.

 

 

c Consult a network administrator.

 

 

 

 

Projector connection

a

 

• When two or more projectors are connected, the image

failure.

 

 

cannot be projected because the resolution of the second

 

 

 

or subsequent projector is lower than that of the first.

 

 

 

c Connect the projectors in order of lower to higher

 

 

 

resolution.

 

 

 

 

28 Others