Location and Function of Controls / Installing the Projector

qj PIC MUTING key

Cuts off the picture. Press again to restore the picture.

qk INPUT key

ql PJ/NETWORK select switch

To use the Remote Commander for network operations, set the switch to NETWORK. Set the

Installing the Projector

This section describes the installation arrangements for installing the projector.

switch to PJ to use the Remote Commander for normal operations other than networking.

w; COMMAND ON/OFF switch

When this switch is set to OFF, no key on the Remote Commander function. This saves the battery power.

wa Transmission indicator

Lights up when you press a key on the Remote Commander.

This indicator does not light up when you use the laser pointer.

Horizontal center of the screen

Vertical center of the screen

Installation area

Install the projector so that the tip of the lens is within this area.

ws Infrared transmitter

wd Laser transmitter

Battery installation

1 Push and slide to open the lid, then install the two size AA (R6) batteries (supplied) with the correct polarity.

Be sure to install the battery from the # side.

2 Replace the lid.

Notes on batteries

•Make sure that the battery orientation is correct when inserting batteries.

•Do not mix an old battery with a new one, or different types of batteries.

•If you will not use the Remote Commander for a long time, remove the batteries to avoid damage from battery leakage. If batteries have leaked, remove them, wipe the battery compartment dry and replace the batteries with new ones.

Notes on Remote Commander operation

•Make sure that there is nothing to obstruct the infrared beam between the Remote Commander and the remote control detector on the projector.

•The operation range is limited. The shorter the distance between the Remote Commander and the projector is, the wider the angle within which the commander can control the projector.

Projection distance

The distance between the lens and the screen varies depending on the screen size.

Refer to the chart on page 28 (GB).

Adjust the vertical and horizontal positioning of the projector.

Vertical positioning (side view)

Adjustable shift range

Screen

You can adjust the angle of projection by performing the shift adjustment (page 19 (GB)). Install the projector so that the center of the lens is between the bottom edge of the screen and the center of the screen.

Horizontal positioning (top view)

Center of the projector

Screen

Adjust the horizontal positioning of the projector so that the center of the lens is aligned with the horizontal center of the screen.

14 (GB)